Miniature N2 Generator ALN-005

This ultra small N2 generator and can be built into soldering robots or attached externally. A 0.5 liter per minute flow rate helps clean soldering surface and eliminate oxidation.

Nitrogen Gas Generator APN-05

This ultra small N2 generator and can be built into soldering robots or attached externally. A 0.5 liter per minute flow rate helps clean soldering surface and eliminate oxidation.

Principles

Principle of Gas Separation

Compressed air is supplied into the membrane to separate nitrogen gas from air. Is is very cost effective method to supply nitrogen vs. using bottled or in plant N2.

N2 Nozzle Iron Tip

The integral N2 nozzle built into the solder iron tip creates an effective pre-heated N2 system. As a result, excellent solder quality can be achieved with minimal amount of nitrogen gas. This technology is very effective due to the pre-heated N2 gas. Oue custom designed unit provides a compact solution for N2 assistance soldering.

Prevent oxidation of the solder

For soldering in the absence of oxygen out of the N2 gas around the tip helps to reduce soldering defects prevent oxidation of the solder surface.

Improved wet-ability of the solder

Since solder wetting is improved by using N2 gas is suitable for high melting point lead-free solder.

Reduced cycle time longer life tip

Extends iron tip life by reducing the oxidation of the soldering iron tip in a nitrogen atmosphere. Since N2 gas passes through the tip of the internal standard, it is effective in reducing cycle time in the preheating phase due to the heating nature of N2 gas.

 

Contact Information

  • Phone: 269-465-3400
  • Email: info@apolloseiko.com
  • Fax: 269-465-3441
  • 3969 West Lemon Creek Road
    Bridgman, MI 49106